Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to use
A, Baby unit (transmitter)
1. Switch the power on by pushing the
Power switch (1) from O to I. When
the power is on, the Power supply
indicator (3) lights up steady green.
If the indicator starts blinking red,
the unit needs to be charged.
2. Select one of the ten channels on
the Channel selector (8). You need
to use a coin or similar object to
turn the channel selector to the
desired position. This is a precaution
to prevent the unit from switching
channels accidentally.
3. You can adjust the sensitivity of the
microphone from 1 to 8 using the
Microphone sensitivity control (2).
The microphone is most sensitive to
sound when it is set to 8, and least
sensitive when it is set to 1. If there
is a lot of background noise, it's a
good idea to lower the microphone
sensitivity. If the surroundings are
quiet, the microphone sensitivity can
be set higher.
4. The Transmitting indicator (4) lights
up red when it picks up sound. It
stays lit for 5 seconds after the sound
has stopped, before it goes back to
stand-by mode. In stand-by mode,
the light is green. While in stand-by
All manuals and user guides at all-guides.com
5. Place the baby unit near your child,
B, Adult unit (receiver)
NOTE! Make sure the adult unit is at least
a couple of metres away from the baby
unit before you switch it on. If the units
are too close to each other, feedback
between the units can create a loud
screeching noise.
1. Switch the power on by pushing the
2. Select the same channel for this
mode, the baby unit emits a signal to
the adult unit at regular intervals to
make sure they are in contact with
each other. This is indicated by the
red light.
with the microphone facing the child.
Make sure the unit is close enough
to pick up sounds from your child,
but not so close that your child can
reach it. 1 metre (3.2 feet) is a good
distance.
Power switch (9) from O to I. When
the power is on, the Power supply
indicator (11) lights up steady green.
If the indicator starts blinking red,
the unit needs to be charged.
unit as for the baby unit, using the
Channel selector (16). In case you
notice any interference or static
noises, select another channel and
implement on both units.
8
Werbung
