Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Alarm shutdown
During the alarm, press the test button to pause the alarm for approximately
8 minutes. The red LED will flash once every 8 seconds, indicating that the
smoke alarm is entering alarm shutdown mode.
If your smoke alarm emits the full alarm signal and you do not
test, the smoke alarm is warning you of a potentially dangerous situation that
requires your immediate attention.
Do not use the alarm shut-off until you have verified that there is no current
fire situation. Do not block the alarm vents or turn off the smoke alarm, as this
will cancel your protection.
Smoke alarms can sometimes respond to cooking fumes or other situations
that are not emergencies. In the event of a known false alarm, your smoke
alarm can be temporarily silenced by pressing the test button. Within 8
minutes, your alarm will automatically return to full sensitivity.
Important Notes
•
Press and release the mute button, the alarm sound will stop.
•
The alarm will mute and go into a reduced sensitivity reset cycle for
approximately 8 minutes.
•
During the reduced sensitivity reset cycle, the red LED will flash once
every 8 seconds.
•
After the reset cycle is complete, your alarm will automatically return to
full sensitivity and the red LED will again flash every 48 seconds.
DANGER
Never ignore an alarm as this can result in injury or death. If
your smoke alarm goes off and sounds an alarm and you are
not absolutely sure where the smoke is coming from, get
everyone out of the house immediately.
EN
21
Werbung
