Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Water
outlet
joint
Water
inlet
joint
Drain
pipe
connection
Water
outlet
joint
Water
inlet
joint
For dual-pipe system and four-pipe cold water coil, the water inlet and outlet joints are G3/4. For four-pipe hot water coil,the
water inlet and outlet joints are G1/2.
The casing of the unit is made of galvanized steel; the air filter is made of nylon fibre, and the aluminum alloy air filter can be
customized; the motor has internal overheat protection and overcurrent protection; a centrifugal rotating fan is used; a
soundproof material such as sponge is used; the fin type heat exchanger is composed of copper pipe and aluminum foil, and
the heat exchanger pipe connection can be changed on site.
4.2.2 Maintenance
Only qualified technicians who have unit and refrigeration system experience can perform maintenance operation.
Proper gloves are required.
Before maintenance or check, disconnect the unit from power supply, keep the main switch closed with warning sign attached,
to prevent others from resuming the power accidentally.
1) Routine maintenance
2) Once every month
Check whether the air filter is clean. The air filter is washable as it is made of fibre. When the unit is operational, make sure you
check the air filter every month.
3) Once every six months
Check whether the heat exchanger and condensate drain pipe are clean. After power disconnection, disassemble the unit to
check the heat exchanger and condensate drain pipe.
Heat exchanger
Casing
Figure 4-2 Diagram of unit (exposed)
Heat exchanger
Return air cover
Figure 4-3 Diagram of unit (concealed)
Air outlet grille
Motor
Filter
Air outlet grille
Motor
Filter
NOTE
9
Drain pan
Electric
control
box
Fan
Base
Drain pan
Fan
Electric
control
box
Werbung
