habitat et jardin RELX4 1421 100152 Montageanleitung Seite 9

Preparation:
You will need to purchase a LPG cylinder。You need a suitable
size LPG cylinder that can be installed to the compartment.
You have to use pressure regulator with an outlet pressure
comply with the appliance category. The flexible tube must be
approved also.
Connect the hose to the hose connector in the control box
Warning:
Always test the hose for leaks with soapy water at both of the
ends.
Warning:
Never use the heater while it is raining, the glass tube would break when it suddenly met
water.
Always turn off the heater while there is a rain.
Never splash any liquid to the glass tube when the heater is working
The glass tube will be extremely hot when it is working, never try to touch it and Keep the
children away from the heater.
Always ensure the heater stands firmly, the glass tube may break if the heater was fell down
onto ground.
Never use the heater if the glass tube has any crack
LIGHTING INSTRUCTIONS
Check and ensure that an AA
battery is inside the ignition
chamber and has power. Ensure the
anode(+) faces outside.
1.Ensure that the control knob is OFF. Slowly open the gas
cylinder valve.
2.Press and turn the control knob to LIGHT position, push the
igniter to generate spark while keeping control knob in pressed
position
3.Check for pilot flame through glass tube. If pilot does not light,
turn control knob to 'OFF' position wait two minutes
minimum and try again from the start. Some attempts may be
necessary.
4.If the pilot alight, keep control knob pressed for 15 seconds then
turn the control knob to 'LOW'.
5.For maximum heat turn control knob to 'HIGH'.
6.To turn heater off, turn control knob to 'OFF'.
7.Close the vlave of the gas cylinder or the regulator after use.
OPERATION
OFF
LIGHT
LOW
HIGH