Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9
TO ADJUST THE BACKREST OF THE SEAT
Press in the button to adjust the backrest of the seat in 3 positions.
10
FITTING THE HOOD
A. Insert the hood fastening part into the guide runner on the sides of the ear flaps.
B. The position of the spokes can be adjusted by moving the hood forwards or backwards
as required.
C. The hood can be locked open, by pressing the catch downwards.
11
TO ASSEMBLE BUMPER BAR
A. Assemble: Align the bumper bar pegs with holes in the front of seat unit and insert into
until hear clicks.
B. Disassemble: Press down both buttons on bumper bar and pull out.
12
USING THE SAFETY SYSTEM
To unfasten the buckle, press the middle button and pull both sides of the harness out-
wards. To fasten the buckle, insert both sides of the harness into the buckle until they click
into place.
13
NEWBORN POSITION
Fit the straps to the children whenever using the pushchair. The two side fastening points
of the seats can be used to fit an extra harness. Your pushchair is approved for newborn
babies. To fit the straps to your baby (when he is under 6 months) pass the shoulder straps
through the lower holes and join the shoulder pads using the Velcro. After 6 months, pass
the straps through the holes that are most comfortable for the child.
14
FOLDING
1. Put the brake on the pushchair. Photo 4a.
2. Make sure the front wheel steering lock is released so that once your Vision is folded
both wheels are facing inwards. Photo 5B-5C.
3. Release the hood catch and pull the spokes backwards. Photo 10C-10B.
4. Recline the seat as far as it will go, until you hear a double click. Photo 9.
5. Fold the handlebar downwards as far as it will go with the two side buttons. Photo 1C.
6. Pull the catches upwards and start the folding action. Photo 1A.
7. Push the handlebar downwards until you hear a double click and put the folding safety
catch on.
WARNING: If you try to fold the pushchair without releasing the front wheel steering lock,
you may break some of the parts.
MAINTENANCE
Keep the metal parts clean and dry to prevent rusting. Grease the mobile parts and mechanisms
regularly with a silicone based spray. Do not use oil or grease. To clean the plastic parts just use
mild detergent and warm water. Do not expose the upholstery to sunlight for long periods of
time. The upholstery may be taken off for washing.
INSTRUCCIONES
GEBRAUCHSANWEISUNG
INSTRUÇÕES
•
INSTRUCTIONS
•
INSTRUCTIONS
•
ISTRUZIONI
15
Werbung
