Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Reinigen Sie das Paddelbrett einschließlich des Ventils mit
Wasser und Seife.
4. Reinigen Sie die Leckstelle gründlich.
5. Schneiden Sie den Fleck so ab, dass es 1,5 cm von der
Leckstelle abdeckt.
6. Tragen Sie eine dünne Schicht Kleber auf den Fleck und die
Leckstelle auf. Warten Sie 2-4 Minuten, bis der Kleber aushärtet.
7. Legen Sie den Fleck auf die Leckstelle und üben Druck aus.
Benutzen Sie das Paddelbrett in den nächsten 24 Stunden
nicht, bis der Kleber getrocknet ist.
6
6
DE
EN
SAFETY INFORMATION
• Read this instruction manual carefully before inflating the board.
• This manual is not a board swimming course. If it is your first
board, or you changed the board to different kind, make sure to
familiarize yourself with the board. Make sure that the wind and
conditions on the water are suitable for the board and that the
board can be steered.
• The board should be used in the intended way. Pay attention for
any damage caused by wear or inappropriate use.
• Every board, no matter the endurance, can become damaged if
it is used inappropriately. Always adjust speed and direction of
the board accordingly to the conditions on the water. Everyone
using the board must be wearing appropriate equipment (life
jacket or other equipment that floats).
• The board has a bulge near the valve. This is normal and every
board has this.
• Do not exceed the weight limitations of the board.
• Do not inflate the board with an air compressor.
• Before using the board, make sure to inflate all of the sections.
• Do not use the board during bad weather and when the
conditions on the water can affect the ability to come back to
shore safely.
• Always have contact with the board, always wear safety harness
that is connected with the board. Wind and water current can
carry the board faster.
• Do not dive directly from the board.
• The board is not designed to be towed by a boat.
• Do not allow children to use the board without adult supervision.
• Do not drink alcohol while using the board.
• Do not use the board after dark or with bad lighting.
• Do not expose the board to direct sunlight after taking it out of water.
• Keep the board away from sharp objects.
• The product is intended for people that can swim.
USAGE
UNFOLDING THE BOARD
Unfold the board on flat and clean surface.
First inflating should be conducted inside, in room temperature.
This way the PCV material will be more flexible, and the process
easier. If the product has been stored in temperature below 0°C,
leave it in 20°C for 12 hours before unfolding.
DE
EN
7
7
Werbung
