Power Supply Connection, Fuses; Functions - Team CB3215 Bedienungsanleitung

English
power supply connection
The Expert-1 is equipped with an automatic 12/24 V switch. The voltage has to be 13.8/28 V
DC with negative grounding. Ensure that the positive and (+, red) and negative (-, black) polarity
is correct, bevor you connect the radio.
The connection of the radio to the power supply, has to be set up by an authorized technician.
Connnect the power cable directly onto the batterie. Do not use a cigarette lighter adapter
because this kind of connectivity might not provide enough currenct for a proper operation of
the radio. Payspecial attention to the correct polarity, when connecting the cable onto the
batterie.
CAUTION
> Please ensure proper polarity.
> Please check the fuse before first use of the radio. Missed or defect fuses need to be re
placed before operation of the radio.
fuses
The power supply cable fixed to the Expert-1 is equipped with one 2A/25V fuse. Only use
the correct fuse. Damages to the radio can occur when using the wrong fuse.
If the fuse blows, determine the cause, then solve the problem. After the problem is resolved,
replace the fuse. If newly installed fuses continue to blow, disconnect the power cable and
contact your authorized dealer or an authorized
servicecenter.
1. Push the cover of the fuse case down and turn
it counter-clockwise.
2. Replace the defect fuse and mount the fuse
case cover.
external speaker
External 8 Ohm speakers must have a 3.5 mm plug which has to be connected to the speaker
connection (7). Beware of the length
of the cable when determining the
position.
microphone connection
Snap the modular RJ-45 plug of the microphone with the latching tab facing down into the
microphone jack (5) located on the front of the radio.
For protection, the plug has a rubber cover. To remove the plug, push the rubber cover on
the bottom to unlatch the tab and pull the plug out.
Please note that for transmission and reception, the microphone has be to connected.
20

FUNCTIONS

The mobile radio Expert-1 can be programmed with the optional software T-UP36. For the cb
version, use T-UP36 CB and for the amateur version, TT-UP36 HAM.
radio feautures and functions:
FTF LCD
12/24 V automatic recognition
alloy body for heat radiation
6 programmable triple-function-keys
38 CTCSS / 104 DCS for rx- and tx-frequencies (optional)
AM/FM
DTMF
PTT-ID - DTMF
SQ/ASQ squelch
RF Gain
Scan
Dual Watch
Warning Tone
Roger Tone, 8 tone sequences programmable via software
Priority Channel 9/19, other channels are programmable via software
Noise Blanker
HIC
8 Memory Channels (only HAM version)
Time Out Timer - TOT
Busy Channel Lockout - transmission blockage on occupied channels
LCD brightness, 1-3
APO - automatic power off
Keylock
Multi-Function-Keys:
MOD (AM/FM), RFG (receipt signal strength), EMG (priority channel 1/2), VOL (volume), SQL
(squelch), POW * (tx-power switch), DSP (channel/frequency display mode), SCA (scan), MEM*
(memory channels), BND* (frequency norm), DW (dual watch), CAL (DTMF call), NB (noise
blanker), RB (roger tone), HIC (high cut - frequency filter), CDT (CTCSS/DCS**), SPL* (repea-
ter mode, +/- frequency shift)
* only HAM version / ** optional
English
21