nedis RDDBCR2000GN Bedienungsanleitung Seite 5

• Do not expose the product to a high pressure of water or
moisture.
• Do not expose the product to water, rain, moisture or high
humidity.
• Do not expose the product to very hot or very cold
temperatures.
• Do not immerse the product in water.
• Do not charge when the product is wet.
• Only power the product with the voltage corresponding to
the markings on the product.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or defective.
Replace a damaged or defective product immediately.
• Do not look directly into the LED reading light, doing so
may damage your eyes.
• Do not drop the product and avoid bumping.
• Extended exposure to high volumes can cause hearing loss.
• Before cleaning and maintenance, switch off the product
and disconnect the power.
• Do not use aggressive chemical cleaning agents such as
ammonia, acid or acetone when cleaning the product.
• Cleaning and user maintenance shall not be done by
children without supervision.
• Do not open the product, there are no user serviceable
parts inside.
Charging the product
Solar panel:
1. Place the solar panel A
The battery indicator A
charging. The battery indicator A
indicate the product is fully charged.
Hand crank:
1. Unfold the hand crank A
2. Turn the hand crank A
product. It takes around 3 – 5 minutes to fully charge the
product using the hand crank.
The battery indicator A
charging. The battery indicator A
indicate the product is fully charged.
3. Fold in the hand crank A
USB charging port:
1. Open the rubber cap A
2. Plug the USB-C cable A
in direct sunlight.
5
r blinks to indicate the product is
r burns continuously to
7 .
to generate power and charge the
7
r blinks to indicate the product is
burns continuously to
r
7 .
.
q
into the USB-C port A
a
5
w .