Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING
WARNING: Do not splash water directly
onto the cooler and do not wash with water.
Short-circuit and electrical shock could re-
sult.
Clean the cooler regularly to keep it clean at
times.
Never use polishing powder, soap powder,
benzene, Oil or hot water as these will dam-
age the painting and Plastic components.
HOW TO CLEAN THE
CONDENSER
It is important to regularly clean the conden-
ser coil every 2-3 months. Heavy buildup of
dust on the condenser can lead to reduced
cooling efficiency, increased energy con-
sumption and possible compressor damage
To clean the condenser, follow these steps:
•
Switch the power off and pull out the
power plug.
•
Remove the front panel to access the
condenser.
•
Use a hoover or a soft brush in a verti-
cal motion to clean the condenser.
CHECKS
To ensure the safety, perform the following
checks after cleaning.
Is the power cord plug firmly inserted into a
dedicated wall outlet? Confirm that the plug
is not abnormally hot.
Check the power cord for cracks and dam-
age. Should the slightest irregularity be ob-
served, contact the dealer from whom you
purchased this unit or our customer's ser-
vice.
This marking indicates that this product
should not be d is posed with other house-
hold wastes throughout the EU. To prevent
possible harm to the environment or human
heaIth from uncontrolled waste disposaI,
recycle it responsibly to promote the
sustainable re use of materiaI resources. To
return your used device, please use the re-
turn and collection systems or contact there
tailer where the product was purchased.
They can take this product for environmen-
taI safe recycling.
How to use
BEFORE USE
Remove shipping package, tape, ate and
leave doors open ventilation for a while.
The unit is cleaned before shipment. How-
ever, clean the compartment interior once
after delivery
Please insert power supply plug into the wall
outlet.
Allow the unit to operate for about 1 hour
to cool the compartment before placing
items in the cooler.
WAIT 5 MINUTES OR MORE BEFORE RE-
STARTING
Restarting the unit immediately after it has
been turned off may cause fuses to blow
and activate the circuit-breaker, the com-
pressor may be overloaded, and/or other
damage may occur.
TEMPERATURE ADJUSTMENT
For glass door cooler, the interior tempera-
ture will be kept at 1-10°C under +25°C am-
bient temperature.
If the ambient temperature is extremely
high or the stuffing food inside is too much,
that might cause the interior temperature a
Iittle bit higher. So, it would be better to ad-
just the digitaI controller by setting a Iower
temperature so as to maintain the right
temperature. 0n the opposite, if the ambi-
ent temperature is very low or empty
Ioaded, or in Iess food storage, the interior
temperature might become very cold, and
in return cause the evaporator to ice up;
Thus, it would be better to re-adjust the
Werbung
