Blaupunkt VIO-DP20 Kurzanleitung Seite 5

Note:
To perform a factory reset press the reset/WPS button
turns off and the red Indicator light turns on and starts flashing. Now wait until the Green Indicator light
flashes slowly. Now the camera is reverted to default settings.
For advanced users who want to configure by WPS instead of the recommended WIFI or Ethernet configuration,
please refer to Web Interface manual. To download the Web Interface manual, please visit our website
http://security.blaupunkt-service.com
Please refer to the following sheet for more details about status of indicator light.
Indicator light status
Red light normally on
Green light slow flashing
Green light quick flashing
Green light normally on
Red and green lights flash
Red light slow flashing
Red light quick flashing
3
for 15 seconds until the green Indicator light
Device status
Booting
Booting completed, await Wi-Fi config, enter smart config
status;
Wi-Fi smart config in progress, including WPS (Wi-Fi
Protected Setup), management frame and etc.
Wi-Fi connection succeeded, operate normally.
Device upgrade
Network connection failure or disconnection after
network connection success.
Device malfunction, fail to boot up; alarm or SD card
malfunction