16
ASSEMBLY
1) Locate a flat, dry area with access to electrical outlet or extension cord. The best
setup position will also make launching easy, so ideally the Cyclone and Cyclone
enclosure tube should be carefully carried into position at the water's edge.
NOTE: Dragging or sliding the Cyclone and Cyclone enclosure over ground either
before or after inflation can cause damage. It is best to attach Aquaglide items while
they are deflated. Once fully attached with Vario-Lock cinch straps, then inflate.
2) Once in the setup/ launch position, unfold the Cyclone and Cyclone enclosure
completely and locate the Main Valve. Remove the Main Valve cover and push valve
plunger in. Twist the valve stem 90 degrees to open or close the 1-Way valve feature.
3) Using a high output pump 2.2 psi (minimum), place the inflation hose with proper
adaptor into the Main Valve to inflate Cyclone and Cyclone enclosure. Inflate to
2.2 psi (0,152 bar). Check for proper air pressure using a manometer. After inflation,
replace Main valve cover. Inflation times can vary by the inflator, but the Cyclone
and Cyclone enclosure should be firm and tight when completely inflated.
DO NOT OVERFILL. Excessively high pressure can cause damage to the product
and may void the warranty. Carefully monitor air pressure in the product especially
during hot weather. Repeat this step for the secondary valve on the Cyclone and
Cyclone enclosure.
Inflate to 2.2 psi (0,152 bar). Check for proper air pressure using a manometer. After
inflation, replace the main valve cover.
WARNING: Do not use an air compressor to inflate the tube. Air compressors are
designed for high pressure inflation and can cause the tube to burst if over-inflated.
WARNING: Do not use Cyclone and Cyclone enclosure without adequate air
pressure 2.2 psi (0,152 bar).
4) You must use an Aquaglide accessory in order to board the product. Please follow
the Vario-Lock instructions in order to properly connect Aquaglide items together.
5) To launch the product, make sure to have at least 4 people evenly spaced around
the product to help carry it. NEVER DRAG THE PRODUCT! YOU MUST LIFT AND
SET THE PRODUCT ON THE WATER TO AVOID ANY ACCIDENTAL TEARING
AND/OR ABRASION.
How to connect your Aquaglide Products using the Vario-Lock cinch strap
Vario-lock cinchs are sold separately