Kettler Toys TRIKETT Montageanleitung Seite 5

Please bear in mind that children are very often not able to judge their own capabilities and cer-
tain (dangerous) situations. Also consider that a natural urge to play plus their temperament may
lead children into unforeseen situations for which the manufacturer cannot be held responsible.
Please ensure that the wheeled toy is only used in surroundings free of danger.
This wheeled toy does not have lights. It is dangerous to use it in the dark.
Handling
Before use always check that all screws and plug-in connections and respective safety devices fit
correctly.
Instruct children in the correct use of the product, and draw their attention to possible dangers.
Sturdy, closed footwear must be worn when using this product.
Please note that pedals on any wheeled toy without freewheeling appliance will turn even if the
product is being pushed or is coasting.
This wheeled toy does not have a so-called parking brake. Therefore secure the vehicle against rol-
ling away. Do not leave children, who are not old enough to use the wheeled toy, unattended on
a product.
If this product can be adjusted please adapt it to your child's height.
Do not transport anything on this product.
Never use corrosive or abrasive substances to clean the toy. Never use substances which may
cause pollution of the environment.
Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every
two or three months.
For models with pneumatic tyres: When leaving wheeled toys with pneumatic tyres on floors con-
taining solvents or which have been glued with such solvents (e.g. PVC) they may possibly stain it
due to a chemical reaction with the natural product caoutchouc. If in doubt place something under-
neath the wheels. Ensure that air pressure in the tyres is correct (2,5 bar); if air pressure is too low
this increases wear, and makes riding the toy more difficult!
For models with push bars: Always ensure that the push bar fits correctly in the adaptor, and locks.
Do not hang any weights on the bar! The vehicle may tip over, and your child may be hurt. The
push bar is intended for adult use only, do not pass responsibility for children on to other children.
For free play time take the push bar off for safety reasons.
Assembly of the toy vehicle
The toy vehicle must be assembled carefully by an adult person. Study the assembly instructions
carefully before beginning work. Assemble the vehicle in the exact sequence shown by the letters
in the diagrams. This is essential for the safe function and use of the toy vehicle.
Please note that there is always a danger of injury when working with tools or doing manual work.
Therefore please be careful when assembling this machine.
Ensure that your working area is free of possible sources of danger, for example don't leave any tools
lying around. Always dispose packaging material in such a way that it may not cause any danger.
There is always a risk of suffocation if children play with plastic bags!
Bolt all the parts together loosely at first, and check that they have been assembled correctly. Tighten
the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts completely
against resistance (locking device). Then check that all screw connections have been tightened firm-
ly. Attention: once locknuts have been unscrewed they no longer function correctly (the locking devi-
ce is destroyed), and must be replaced.
When assembling plastic grips: The grips can be pushed onto the handlebars more easily if they
are first soaked in warm water.
Please keep original packaging of this article, so that it may be used for transport at a later
date, if necessary.
For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition
of tubing plugs).
5