Arwin Tools AGS44 Originalbetriebsanleitung Seite 19

9. TROUBLE SHOOTING
PROBLEM
The motor does
not run
The material to
be chopped is
not drawn in
CAUSE
Safety swith
Power failure
The material is jammed in the
feeding funnel
Shredding material is too soft
ACTION
Check if the switch still functions well.
Check the power supply cable, the plug and
the house fuse.
Switch the shredder OFF.
Pull the material from the feed funnel.
Switch the shredder back ON and re-feed
thick branches such that the blade dose not
immediately engage the pre-cut notches
again.
Insert wood or shred dried branches.
Press the reset button and then the On/Off
switch. If it still does not start, take the steps
indicated on page 6 'Overload Protection'
section.
19