ELECTRICSUN ESfocar23C Installations- Und Benutzerhandbuch

EN
ATTENTION:
1. Find a location for the electric heater that is protected from direct sunlight.
2. Do not plug the electric heater into the power outlet before you read all instructions.
Fast Menu for Heating: Press
OPERATING INSTRUCTIONS
Once the electric heater has been properly installed and connected to a ground electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for the power supply are turned on.
The I/O switch is on the left of the outlet. And the other controls are located right of the heater outlet.
0/1
Press this switch, the unit power-on. When the O/I switch is turned off, all other functions will stop even though the
0/1
buttons may be in the ON position
Press this button, the unit will enter standby mode. The unit will beep and the indicator light will be on. Then you can
select the following functions as desired. Press again to turn off the heater.
The OK key switches (changes) between the + and – keys for setting the temperature and the up/down arrow for
OK
setting the sound.
To adjust the volume of the fire SOUND: press OK and up arrow to increase sound volume, press OK and down arrow
to decrease the sound volume
For heat function - Press this button to turn on the heat function. Press again to turn off
For flame function - Press this button to turn on the flame. Press again to turn off.
For flame effect function - Press this button to change flame effect. Press again to decrease the flame intensity. There
are 4 light intensities for your selection. The flame optics will go lower under the sequence of 4,3,2 and 1. Pressing
the button again will go higher under the sequence of 1,2,3 and 4.
For Window detection function - Press this button to turn on the window detection function. During the heating
process, if the room temperature drops obviously caused by the outdoor cold air blowing, such like open windows or
open the door. In order to save energy, the heater will automatically stop heating. The corresponding icon on the
screen will twinkle. Press again to turn off the window detection function to normally heating
For modification time function - Press this button, the 'SUN' on the LED screen starts to twinkle. Press up
button to the desired date, and press
button switch to the 'hour' position. Press
'minute' position. Press
NOTE: The date will be reset after power interrupt.
For automatic working time setting function - There are 10 time periods you can set to make the unit work
automatically. Press this button, time serial number starts to twinkle. The 'ON' on the LED screen lights up. Press
button to the desired serial number. Press
or down button to the desired date, and press
desired date, press
ELECTRIC FIREPLACES ELECTRICSUN®
INSTALLATION AND USE MANUAL
, press , then press
Control panel
or button to the desired minute. Press
button switch to the 'hour' position. Press
Page 1
to increase temperature degree.
LED screen
button to select, press button to cancel. After set the desired date, press
or button to the desired hour. Press
button again, the 'SUN' on the LED screen starts to twinkle. Press up
button to select, press
or
Remote control
button switch to the
or button to complet date setting
button to cancel. After set the
button to the desired hour. Press
or down
or