iOttie Auto Sense 2 Bedienungsanleitung Seite 6

Using the Auto Sense Mechanism
Once it is unplugged or the car is turned off, the Auto Sense's
internal battery keeps a charge for up to one hour.
Mounting and Charging
1. Hold the phone in front
of the mount cradle to
activate the automatic
clamping arms.
Releasing Device
Release buttons are located on
either side of the mount cradle.
To release your phone simply
press one or both buttons and
the arms will open. The release
buttons can also be used to
open the mount arms.
Note: The Auto Sense is powered via a USB-C cable and coil cell
battery. There is no on/off switch. Once it is plugged in, the device
will remain on unless the vehicle is turned off.
10 EN
2. Place the phone inside
the mount. The arms will
close automatically after
one second and wireless
charging will begin.
Adjusting the Mount
Cradle Knob
To rotate the cradle, loosen the
cradle knob. Tighten to lock
into desired position.
03 Qi Alignment Guide
The Qi receiver coil is usually located in the center of the
phone. Check your phone's manufacturer for Qi coil location.
The Qi coil on the mount is located at the top, above the iOttie
logo. Please line up your phone with the device for optimal
wireless charging.
Apple
iPhone
Note: For larger phones and cases, the bottom foot will need to be
extended to ensure proper alignment.
Bottom Foot
The foot can be adjusted up
and down to fit any size phone
by pulling down or pushing up.
Samsung Google
Galaxy Pixel
11