Mounting Location - NXS NX200.2 Benutzerhandbuch

Before you start the installation, it will be necessary to find a mounting location for the
amplifier. Find a location in which the amplifier will receive adequate ventilation in order
to dissipate the heat it develops during operation. Two popular mounting locations are
in the trunk or under the seat.
Select the location in which you wish to mount the amplifier. Use caution when
mounting amplifier, there are many wires, gas lines, vacuum lines, brake lines as well as
a gas tank in the automobile. Make sure you know where they are when mounting the
amplifier to avoid puncturing lines, shorting wires or drilling holes in the gas tank. Once
you are ready, use a pencil to mark the mounting holes in the bottom panel. After you
have marked the locations of the holes move amplifier out of the way and drill small
starter holes to make the tapping screws easier to install. Use provided screws to
tighten down the amplifie
M
OUNTING LOCATION
r.
HIGH LEVEL INPUT OUTPUT
PRIMARY AMP MULTI-AMP LEVEL REMOTE
INPUT CH1 CH3 L
ADDRESS ADDRESS CONTROL
AUTO SENSING
LEVEL
ON
OFF ON
8 4 2 1 A 1/2 3/4
MIN MAX
DSP NETLINK
CH1&2 CH3&4
NX400.4
CH2 CH4 R
IN OUT
SPEAKERS
CH1 CH2 CH3 CH4
FUSE
PWR
OFF
PRT
60A
BRIDGED
BRIDGED
6
POWER
+12V REM GND