Speaker Connections - NXS NX200.2 Benutzerhandbuch

Make the speaker connections using speaker wire that is at least 16 gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential
for strong bass response. When connecting, make sure that positive (+) from the
amplifier is connected to the positive (+) of the speaker, and the same for negative (-).
Please note that although the NX2000.1 and NX1000.1 are mono amplifiers,
provided two sets of speaker terminals on the amplifier. These terminals are connected
in parallel internally (connected together). The second set of speaker terminals are
intended for ease of connection when running multiple woofers.
POWER
GND REM +12V
NX500.1 CONNECTIONS
HIGH INPUT
PRIMARY AMP MULTI-AMP LEVEL INPUT
LEVEL
L
REMOTE ADDRESS ADDRESS CONTROL
LEVEL
AUTO SENSING
ON
OFF
8 4 2 1 A SW
ON OFF
MIN MAX
DSP NETLINK
R OUT
IN OUT
- -
- -
Dual 4 Ohm Woofer
NX1000.1 & NX2000.1 CONNECTIONS
S
PEAKER CONNECTIONS
PRIMARY AMP MULTI-AMP LEVEL
ADDRESS ADDRESS CONTROL REMOTE
AUTO SENSING
FUSE
PWR
ON
ON OFF
OFF
8 4 2 1 A SW
DSP NETLINK
PRT
60A
NX500.1
IN
POWER BRIDGE SPEAKER
IN
MODE
MASTER SLAVE
PRT PWR
NX1000.1
- -
+ +
- -
+ +
(*1 Ohm Load)
Dual 4 Ohm Woofer
HIGH INPUT OUTPUT SPEAKER
LEVEL INPUT
LEVEL
L
MIN MAX
R
OUT
- -
+ +
- - + +
Dual 4 Ohm Woofer (2 Ohm)
(2 Ohm Minimum)
IMPORTANT! The speaker connections
shown for the NX1000.1 is a normal mono
configuration. If you are using more than
one NX1000.1 or NX2000.1 in a Power
Bridge configuration, please see speaker
connections in the Power Bridge section of
this manual.
**CAUTION! The NX1000.1 and NX2000.1 must
+ +
see a 1 Ohm load or higher. Any lower than 1 Ohm
+ +
will cause the amplifier to overheat and possibly
cause permanent damage to the amplifier!
14
**CAUTION! The NX500.1
must see a 2 Ohm load or
higher. Any lower than 2 Ohm
will cause the amplifier to
overheat and possibly cause
permanent damage to the
amplifier!
we have