Signal Connections - NXS NX200.2 Benutzerhandbuch

Connect the RCA output of the head unit (AM/FM cassette player, CD, or DAT) to
the RCA input terminals of the amplifier.
To make these connections, we recommend high quality RCA cables, which are
available at your local car audio retailer. Run signal wires away from electrical wires to
avoid possibility of induced noise from the car's electrical system (i.e. popping noises or
engine noise). Please note that when making these connections the signal inputs
correspond with the speaker outputs.
HIGH INPUT
PRIMARY AMP MULTI-AMP LEVEL INPUT
LEVEL
L
REMOTE ADDRESS ADDRESS CONTROL
LEVEL
AUTO SENSING
ON
OFF
8 4 2 1 A SW
ON OFF
MIN MAX
DSP NETLINK
R OUT
IN OUT
NX1000.1 & 2000.1 CONNECTIONS
The NX400.4 allows for two or four channel input configurations. This gives the
flexibility of using only two channels of input and the amplifier automatically divides the
signal internally for four channels of output (Non Fading). The four channel input
configuration offers normal independent operation allowing for front and rear fading
capability through the head unit.
HIGH LEVEL
INPUT
LEVEL
MIN
CH1&2 CH3&4
NX400.4
NX400.4 CONNECTIONS
USING TWO CHANNEL INPUT
S
IGNAL CONNECTIONS
POWER BRIDGE SPEAKER
IN
MODE
MASTER SLAVE
PRT PWR
NX1000.1
INPUT OUTPUT
PRIMARY AMP MULTI-AMP LEVEL REMOTE
CH1 CH3 L
ADDRESS ADDRESS CONTROL
AUTO SENSING
ON
OFF ON OFF
8 4 2 1 A 1/2 3/4
L L
MAX
DSP NETLINK
CH2 CH4 R
IN OUT
Optional full range output
for additional amplifiers in
the system.
LEVEL
NX200.2, 400.2 & 500.1 CONNECTIONS
SPEAKERS HIGH LEVEL
CH1 CH2 CH3 CH4
FUSE
PWR
CH1&2
PRT
60A
NX400.4
BRIDGED
BRIDGED
NX400.4 CONNECTIONS
USING FOUR CHANNEL INPUT
10
HIGH INPUT OUTPUT
PRIMARY AMP MULTI-AMP LEVEL
INPUT
ADDRESS ADDRESS CONTROL
REMOTE
LEVEL
AUTO SENSING
ON
L L
OFF
ON OFF 8 4 2 1 A SW
MIN MAX L L
R R
NX400.2
Optional full range output
for additional amplifiers in
the system.
INPUT POWER OUTPUT
PRIMARY AMP MULTI-AMP LEVEL
INPUT CH1 +12V REM CH3 GND L
ADDRESS ADDRESS CONTROL
LEVEL
ON
OFF
8 4 2 1 A 1/2 3/4
L L
MIN MAX
DSP NETLINK
CH3&4
CH2 CH4 R
IN OUT
Optional full range output
for additional amplifiers in
the system.
DSP NETLINK SPEAKERS
L R
PWR
IN OUT
PRT
BRIDGED
SPEAKERS
REMOTE
CH1 CH2 CH3 CH4
AUTO SENSING
P
OFF
ON
P
BRIDGED BRIDGED