RBSports 34508 Montage-, Bedienungsund Trainingsanleitung Seite 28

Assembling the bounce mat
3
0/88
66 22
44
0/88
77 11
4
55 33
82
5
5
0/88
71
16
60
27
49 38
3
6 85
0/88 8
80
14
74
19
69
25
63
30
58
36
52
41
47
7 0/88
8
(8)
Step 8: Affixing the safety labels. Put on
the labels with the safety warnings with
cable connectors on the trampoline.
Attach them on the cross-frame
between the two support legs at the
position where later the entry opening
will be put together.
Step 9: Assembling the frame cover:
1. Place the frame cover (2) over the
trampoline so that the springs and
steel frame are covered. Please be
sure that the frame cover covers all
metal parts (fig. 13).
2.Firmly connect the frame cover to the
frame by using bands on its underside
(fig 14).
The warning notice located on the
frame cover should be at the same
position as the safety label or the
notice on the bounce mat.
9
Abb. 13
Abb. 14
Assembly
The warning label should be placed
midway between the two support legs.
There should not be any horizontal
support leg tube underneath.
Step 10: Take care that the outer edge
of the frame cover overlaps the steel
frame. Pull on the drawstring found on
the outer edge of the frame cover and
tighten it.
10
Be sure the frame cover is tied
down correctly, as a slipping frame
cover while the device is in use
can lead to injuries.
When attaching the safety label
and the frame cover, make sure
the notices and warnings are visi-
ble at the entranceway.
The safety label should be between the
two support legs and on the same spot
as the notice on the bounce mat.
Trampoline Trampolin 27