Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
plate.
Interior view
1. Jumper connections for selecting the partition, learning in
the alarm centre, defining the emitted tones and adjusting
the alarm tone volume
2. Screw terminal block for 4.5 and 12 V connections
3. Screw terminal block for internal piezo signaller
4. Wireless reception module
5. LED
6. Piezo signaller
5
2
6
Attaching the rear housing wall
1. Using the base plate as a drilling template, mark the drill
holes on the wall. Drill the holes and insert wall plugs if
necessary.
2. Feed the connection cable of the PSU into the device and
screw the rear housing side onto the wall (optional).
3. Supply the internal siren with power (either 4.5 V or 12 V,
or both - the polarity of the terminal block is printed on the
PCB).
Assigning the Secvest to the wireless internal siren
1. Set the "LEARN" jumper. LED1 starts to flash. Learning
mode is now active.
2. In the installer menu of the wireless alarm centre, select
12
1
4
3
Werbung
