Pur Line HYDRO 12 Anleitung Seite 9

EN
OPERATION
CONTROL PANEL
1. POWER button: plug the power supply and press the power button, the LCD screen lights up and the
appliance starts to work with high mist. Press again to turn off the humidifier.
2. HYGROSTAT button: press once to select the desire level of humidity. The default humidity is 40%, it can be
increased by 5% until 90%, the humidifier will stop working when the humidity reaches the selected humidity
value.
3. TIMER button: the working time can be adjusted from 1 hour to 12 hours. Press this button to display the
corresponding time.
4. SLEEP button: press to turn off the LCD display. Press any button to illuminate the LCD display again.
5. HUMIDIFY button: press this button to adjust the humidifying level: high - medium - low. The default
humidification level is high intensity.
AROMATHERAPY FUNCTION: Before turn on the humidifier, add a few drops of essential oil into the
aromatherapy box.
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
"white powder" problem and give heavy scum on the surface of water basin, transducer and inner surface of
the water tank. Scum on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
• Use filtered water or distilled water.
• Clean the transducer, water tank and basin unit every week.
• Change the water in water tank more often to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use.
HOW TO CLEAN THE TRANSDUCER:
1. Put 5-10 drops of vinegar on the surface of the transducer, wait for 2-5 minutes.
2. Brush out the scum on the surface.
3. Rinse the transducer with clean water.
HOW TO CLEAN THE BASIN UNIT:
1. Clean the water basin with soft cloth and the vinegar if there is scum in it.
2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with the brush.
3. Rinse the water basin with clean water.
7