Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.2
INSTRUCTIONS
FOR
FINAL
Front brake and rear wheel brake pedal are moving
Step
1. Unfold
Citybug2S
Make sure
power
switch
is turned
OFF.
>
Remove
the handlebar
from
plastic
clamp.
>
Pull the lever and lift the alloy tube to normal riding
>
position.
2. Assemble
the
handlebar
Put handlebar
on the quick-release
stem in position.
Tighten
the quick-release
stem
securely.
>
3. Charge
The battery
in your electric
scooter
might not be
>
fully
charged.
The battery
needs
to be fully
charged
before
first
use (see chapter
5.1 for
charging
details)
Inflating
the tire
4.
The front tire is inflated
when shipped.
However,
tire
pressure
may be low when
you received
escooter.
Please
always
inflate
tire to the
suggested
PSI-36
P.S.I. before
your
every
riding.
8
ASSEMBLY
freely
with no interruption.
Sketch
.0
your
36PS1..
Once
assembled,
please
check
• The handlebar
and quick-release
stem
are fully
• Power
ON/OFF
switch
is working
properly.
• Quick-release
lever is tightened;
failure
to do so may cause movement
may result
in loss of control
of the vehicle.
• Front brake and rear wheel brake pedal are moving
the
following
locked,
with
no movement
or noise.
of alloy tube
riding,
which
freely
with no interruption.
9
Werbung
