CityBug CITYBUG2S Bedienungsanleitung Seite 15

IO.TROUBLE SHOOTING
Problem Potential Cause
Motor doesn't start CityBug2S needs to speed
to 5 km/h by manpower
Battery needs to be charged
Check if your charger
working properly
Short run time Check your battery
(less than 15 minutes charge
per charge) Battery is old and will
not accept full charge
26
Solution
Speed up to 5 km/h by manpower.
up
Charge your battery. Make sure the charger
connector is plugged into the charging
and that the charger is plugged into the
socket.
is Make sure there is power to the wall socket.
Contact the CityBug Service Centre
diagnosis and repair.
status Charge battery until full or to at least 4 LED
lights on battery status indicator.
Contact CityBug Service Centre for
diagnosis and repair.
Problem
CityBug2S
sluggishly
port,
for
Scooter does
every time
Motor still
rear wheel
engaged
Potential Cause Solution
runs Riding conditions are Ride only
too strenuous
CityBug is overloaded Avoid exceeding
(for highest
weight of rider should not exceed 100 kg).
Motor is overheated For safety
motor power
starts rising rapidly
conditions.
to cool down or ride on flat surfaces
not run Loose wires or Check wires
connections CityBug
Motor or electricity Contact
damage diagnosis
runs when Brake sensor failure Contact
brake is diagnosis
on solid, flat, clean and dry surfaces.
maximum load of 100 kg
system efficiency, the maximum
reasons, system will reduce or stop
completely if motor temperature
due to extreme riding
Please stop riding to allow the motor
only.
and connections or contact
Service Centre.
CityBug Service Centre for
and repair.
CityBug Service Centre for
and repair.
27