Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION ADVICE
REMOVE THE MCPHERSON SPRING STRUT
•
Select jaws according to table at scangrip.com and mount on the spring compressor. Fit the
retaining bolts and tighten firmly. It is very important for your safety that the bolts of the
jaws are firmly tightened.
•
Rotate the drive nut to drive the jaws apart to match the length of the spring and to com-
press as many windings as possible.
•
Place the coil spring compressor in the built-in protective accessory in a suitable vice.
•
Place the spring strut onto the coil spring compressor. Take care that the seating of the
spring windings in the jaws is correct.
•
With an impact wrench or a racket spanner, turn the drive nut until the upper support bear-
ing is free. Additional compressing is permitted. When using impact wrench do not exceed
120Nm torque limit.
Werbung
Inhaltsverzeichnis
