Inhaltsverzeichnis
Werbung
4.8.
When parking the machine, you are recommended to lower
the brush head to anchor it to the ground.
4.9.
The machine has a rapid brush replacement system:
1- turn the key to the off position (anticlockwise as far as it will go),
2- use the pedal to lift the brush head,
3- hold the brush with both hands and turn it sharply in the normal
direction of rotation. In the case of heads with two motors, the
direction of rotation is always towards the centre of the head.
Hold the bayonet coupling firmly in position and release the
brush.
4- remove the brush and position the replacement in the centre of
the housing, precisely under the bayonet coupling,
5- use the pedal to raise the brush head,
6- switch the appliance on and activate brush rotation for a few
moments, then turn off again,
7- finally, raise the brush head and make sure the brush is correctly
fitted. If necessary, repeat operations 1 to 6.
4.10.
The key switch should be turned off before recharging the
batteries.
4.11.
In order to avoid any build-up of gas inside the machine,
the tank (previously emptied) covering the batteries must
be raised and remain in that position throughout charging.
Similarly, the caps of all battery cells must also be
unscrewed and/or removed (not necessary in the case of
maintenance-free gel batteries).
Battery gas is highly explosive. Avoid sparks and open flames near
the batteries.
When topping up with distilled water make sure the level of liquid is the
PRECAUTIONS
ENGLISH 13
Werbung
Inhaltsverzeichnis
