Beper VE.150 Betriebsanleitung Seite 10

Retro Stand Fan Use Instructions
Product and accessories Fig.A
1 – Front guard
2 – Fan blades
3 – Fan blades screw
4 – Fixation screw
5 - Rear guard
6 – Motor shaft
7 – Speed control
8 – Fan motor
9 – Power cord
Fan assembly Fig.B
Attaching the telescopic stand to the stand base.
First unscrew the l-shaped screw and remove it and the clamping washer from the bottom of the telescopic
stand.
Turn over the stand base. Place the weighted base centre in its place on the underside of the base and the
clamping washer in the centre of the weighted base.
Thread the l-shaped screw through the assembly and into the thread in the telescopic stand. Tighten firmly, but
do not overtighten.
Loosen the height adjustment knob and pull he inner tube out the telescopic stand to the desired height, then
retighten the knob. Attaching the motor housing to the top of the telescopic stand.
First remove the pivot knob and the bolt from the top of the telescopic stand, then remove the neck retaining
screw and small adjustment knob from the motor housing bracket.
Place the motor housing on the top of the stand and thread the large pivot bolt through the bracket. Screw in the
small retaining screw and tighten, but do not overtighten.
Fit the large pivot knob onto the end of the bolt and the small adjustment knob at the other side above the bolt.
Tighten the knobs while holding the fan motor upright.
Attaching the guards and fan blade
First remove any protective sleeve from the motor shaft and the four rear guard retaining screws from the motor
housing. Attach the rear guard to the motor housing using the four screws you just removed. Ensure the handle
is at the top. Place the fan blade over the motor shaft and tighten the fan blade retaining screw, ensuring that it
tightens against the flat part on the motor shaft.
Remove the front guard screw and nut from the front guard and turn the guard retaining clips around the outside
edge outwards. Hang the front guard by its hook over the top of the rear guard. Bring the front guard down to
meet the rear guard and push the clips inwards until the front guard is fastened to the rear guard. Finally fit the
guard screw through the holes in the bottom edge of the guard and tighten with the nut.
Speed selection
Choose the speed desired pressing on the buttons of the control panels.
Position 0 the fan switch off.
Position 1 low speed.
Position 2 medium speed.
Position 3 high speed.
Head inclination
It is possible to choose various positions and change the air flow swing.
Before changing it, switch off the fan.
Take the motor body, unscrew the regulation axis and change the inclination of the fan as desired and screw the
air strongly.
Do not try to force the inclination position in order to avoid any failure.
Swing
It is possible to activate or disconnect the swing of the fan, by touching the swing axis (8). Swing allow to provide
the air uniformly.
To activate the push the swig axis (8) down until completely blocked ; the head fan turns automatically from right to left.
To disconnect the swing raise completely the axis (8).
10 – Knob
11 - Inner tube
12 – Height adjustment Screw
13 – Outer tube
14 – Base
15 – Wheight
16 – Fastener
17 – Locking screw
9
EN
10 / 58