Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Apply the pulling tool until the dent area is restored.
Remove the adhesive pad and the rest of the hot glue with a
commercially available 90% acetone-water solution. After
cleaning the surface should be polished.
Attention
- Place a piece of cardboard under the nozzle and make sure the hot glue gun has a firm stand.
- Keep the hot glue gun never with the nozzle to the top.
- Do not use hot glue cartridges that are not be suitable for use in the hot glue gun.
- Never use other adhesives.
- Pull the plug from the outlet when the hot glue gun is not used.
- This device is not a toy! Please keep out of the reach of children.
- Nozzle and adhesives are extremely hot. Not touch!
- If skin came in contact with adhesives, rinse immediately with water
- When not in use, always store the hot glue gun in holder
- Never put the glue gun flat on a table.
- Use only 11 mm hot glue sticks.
Using the hot-glue gun
Run the hot glue cartridges from back in the hot glue gun, and press the trigger until the cartridge is
firmly seated in the guide channel.
Now connect the hot glue gun to the wall socket.
Store the hot glue gun with the nozzle down on the stand.
After 5 to 10 minutes, the optimum operating temperature is reached.
Press the trigger until the hot glue comes out the nozzle.
Press the work pieces together immediately.
Only clean and dry materials stick together.
Opend hot glue cartridges always leave in the device.
Do not pull the Cartridges against the direction of thrust from the guide channel of the hot glue gun.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Werbung
