GreenWorks GD24DD60 Bedienungshandbuch Seite 6

WARNING
Be prepared for binding at bit breakthrough. When these
situations occur, drill has a tendency to grab and kick
opposite to the direction of rotation and could cause loss of
control when breaking through material. If not prepared,
this loss of control can result in possible serious injury.
4 OPERATION
WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
4.1 START THE MACHINE
Figure 6.
The machine can not work until the reversing button is
pushed fully to the left or right. Do not operate the machine
at low speeds for extended periods of time.
1. Push the switch trigger to turn the machine ON (I).
4.2 STOP THE MACHINE
Figure 6.
1. Release the switch trigge to turn the machine OFF (O).
WARNING
Release the switch trigger and let the coupler to come to a
complete stop.
4.3 ADJUST THE VARIABLE SPEED
Figure 6.
1. Increase the trigger pressure to make a higher speed.
2. Decrease the trigger pressure to make a lower speed.
4.4 ADJUST THE TWO-SPEED GEAR
TRAIN
Figure 7.
The machine has a two-speed gear train designed for drilling
or driving at LO (1) or HI (2) speeds. A slide switch is on top
of the machine.
1. When you use the machine in the LO (1) speed, the speed
decreases and the machine has more power and torque.
2. When you use the machine in the HI (2) speed, the speed
increases and the machine has less power and torque.
NOTE
English
Use LO (1) speed for high power and torque applications
and HI (2) speed for fast drilling or driving applications.
4.5 SELECT THE MODE
Figure 8.
To change the operation mode, adjust the mode selection ring
to the correct position.
The machine is used for three functions: driver (a), drill (b)
and hammer drill(c).
Torque can not be adjusted until the driver (a) mode starts.
A. The direction to decrease torque.
B. The direction to increase torque.
When hammer drilling, do not apply too much pressure.
4.6 ADJUST THE REVERSING
BUTTON
The machine has the reversing button (forward/reverse lock)
above the switch trigger to chang the direction of the bit.
Figure 9 - 10.
1. When the reversing button is on the left side of the switch
trigger, the bit direciton is forward.
2. When the reversing button is on the right side of the
switch trigger, the bit direction is reversible.
3. Put the direction button in the OFF (center lock) position
to help decrease the possibility of accidental start when
not operate.
Release the switch trigger and let the chuck to come to a
complete stop to stop the mahcine.
Let the chuck to come to a complete stop before changing
the direction of rotation.
The machine does not operate until the direction button is
pushed fully to the left or right.
4.7 DRILL MATERIALS
• When drilling hard, smooth surfaces, use a center punch
to mark the desired hole location. This can prevent the
drill bit from slipping off-center as the hole is started.
5
WARNING
NOTE
NOTE
WARNING
WARNING
NOTE
EN