neno Pressione Bedienungsanleitung Seite 16

Function is possible only if the device is switched off or after the measure-
ment has been completed.
2. Switching voice messages on/off:
To activate the voice prompt function, move the volume button to the left.
If you want to turn off the voice prompt function, move the volume button
to the right.
3. Unit change:
To change the unit, press and hold the user change button while the unit
is switched off until the display shows the currently set unit. To change the
unit, press the memory button. The unit will automatically switch over, no
need to confirm the selection.
09. USE
CUFF
1. Lay the cuff flat with the Velcro side down. Thread the end of the cuff
through the metal ring to form a loop. The Velcro of the blood pressure cuff
should point outwards. SEE FIG. E. 1.
2. Insert your hand into the loop formed and pull so that the cuff ends 2-3 cm
above the elbow. Check that the moccasin is placed in the right direction
based on the „ Φ „ symbol on the cuff. The air tubing runs along the inside
of the arm as shown in SEE FIG.E. 2. Put on the cuff as shown in SEE FIG.E.
2. , make sure the bottom edge of the cuff is 2~3cm from the elbow joint,
and that there is room for 2 fingers between the cuff and the arm. Velcro the
free edge of the cuff.
3. Remove tight clothing and thick clothing from the arm before measuring.
Lay your forearm flat on a table, leaving the inside of your hand naturally up.
Remember to sit upright and make sure the cuff and heart are at the same
level. Note that the air tube must not be compressed or bent. SEE FIG. E. 3.
Note: If you cannot measure on the left arm, use the right arm to measure. Only
compare results taken on the same arm.
MEASUREMENTS
1. Press the power button and the device will automatically display 0, after
which the air pump will start inflating the cuff and the screen will show the
change in cuff pressure.
2. Once a stable pressure has been reached after inflation, the pump will stop
running and the cuff pressure will gradually decrease, as can be seen on the
screen. If the inflated pressure is insufficient, the device will automatically
re-inflate the cuff to achieve a higher pressure.
3. When a pulse is detected, the ‚heart' symbol appears on the screen and
starts flashing.
16