Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
SECURITY CHARACTERISTICS
The max inlet pressure is 0.8 Mpa.
● Following warning sentences:
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
● The pressure-relief device (safety valve) is to be operated regularly to remove lime
deposits and to verify that is not blocked.
● CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this appliance must be not supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
● This appliance is not intended for use by persons with reduced physical, sensory, or
mental capabilities, or lack of experience and knowledge, unless they are under the
supervision of a responsible person or have been given proper instruction for using the
appliance. Children aged 8 and older are allowed to use the appliance independently if
given adequate instructions concerning safe use and potential hazards. Children shall not
play with the appliance.
● This electrical water heater must be installed with a mono-directional safety valve at
the inlet pipe (blue indicator) when the tank's pressure is over 0.8 MPa. Water will
automatically flow out from the drain pipe outlet of the safety valve (Diagram 1) if
pressure exceeds 0.8 MPa. In any condition, this outlet must not be blocked.
● If you need to empty the water in the tank, first close the water mains. Remove the
fixed screw nail on the safety valve, lift up the plastic handle (Diagram 2), so that the
water can flow out naturally.
Fixed srew nail
Water-drainage position
Safety valve outlet
Water-drainage Spanner
Diagram 1
Diagram 2
23
Werbung
