Volvo Penta Neutra-Salt Einbauanleitung Seite 8

6
50104
50105
50107
4. Use contact plate as a template to mark four holes
to be used for attaching contact plate.
5. Drill four pilot holes. The size of the holes is
determined by hardware used (hardware is not
supplied with this kit).
6. Install contact plate on control panel with
hardware.
7. Install the rocker switch into the contact plate. A
"SNAP" sound will confirm when the rocker switch
is securely seated in the hole.
8. Install decal (4), PN 7741899, on control panel,
near switch.
OPTION 2: WITHOUT CONTACT PLATE
1. Find a flat surface on control panel where rocker
switch will be mounted
2. Cut out Template B, located on back page. Using
it, mark area to be cut out.
3. Cut out marked area.
VPA 47702052 11-2011