Herunterladen Diese Seite drucken

natus Nicolet Benutzerhandbuch Seite 85

Werbung

Fehlercodes
Fehlercodes
Fehlermeldung
Fehler 20
Impulslänge von Phase A zu kurz
Fehler 21
Impulslänge von Phase B zu kurz
Fehler 22
Impulsfrequenz zu niedrig
Fehler 23
Train-Dauer zu kurz
Fehler 24
Gegenwärtige Spannung der Stimulation falsch.
Fehler 25
Eine oder mehrere der Stimulus Switching Unit /
Stimulations-Schalteinheiten (SSUs) sind nicht
verfügbar oder nicht bereit.
Fehler 26
Dekoder-Übertragungsfehler
Fehler 27
Ein Dekoder wurde abgetrennt.
Fehler 28
Es fließt fälschlicherweise ein Stimulations-
Strom.
Fehler 29
Unerwartete Stimulation
Überarbeitet 2020-04-21
Allgemeine Informationen
Action
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
Stimulator is in "Electrode Biphasic" mode but
does not detect a viable SSU through which to
deliver the current.
If using as a stand-alone stimulator: Switch to
"Probe Biphasic" mode.
If using SSU mode, but no SSU is connected:
Connect a properly configured C64OR/SSU
amplifier(s).
If using SSU mode and C64OR/SSU amplifier(s)
are already connected: Troubleshoot
connection(s) and configuration(s) of C64OR/
SSU amplifier(s).
SSU verification feedback of assigned channels
does not match channels assigned by SCU.
Troubleshoot connection and configuration of
connected C64OR/SSU amplifier(s). If no issues
are found, replace the SSU amplifier(s).
SSU failed to return channel assignment
verification response to SCU. Troubleshoot
connection and configuration of connected
C64OR/SSU amplifier(s). If no issues are found,
replace the SSU amplifier(s).
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
Press Stop. Reset stim value. Press Start. If error
repeats, replace control unit.
5-3

Werbung

loading