Navitel R35 Benutzerhandbuch Seite 19

Installation
1. Put the microSD card into the DVR. Use a high-speed SD card (ClassU3 or above); capacity should be within 8-128 GB.
• To avoid malfunctions of the DVR and / or SD-card, don't insert and remove SD-card during DVR operation.
• Before using a microSD card, please format it inside the DVR to avoid data errors. To format the SD-card in Navitel DVR Center mobile
application navigate to Settings — Format SD card.
2. Stick the electrostatic film on the windshield and fix the DVR over it with the mount.
3. Connect the car charger to the cigarette lighter socket.
4. Connect the car charger to the DVR power connector (USB-C).
5. Adjust the camera position.
6. Turn the power on; check whether the DVR is installed correctly. If the DVR is installed correctly, the display will light up.
Precautions
• Use only the original charger adapter. Using another adapter may negatively affect the device's battery. Use accessories only approved by manufacturer.
• Permissible ambient temperature in operating mode: 0 to +35 °С. Storage temperature: +5 to +45 °С. Relative humidity: 5% to 90% without condensation (25 °С).
• Put the device away from fire sources to avoid explosion or fire.
• Do not expose the device to physical impacts.
• Avoid contacting the device with sources of electromagnetic radiation.
• Keep the lens clean. Do not use chemicals or detergents to clean the product; always turn off the device before cleaning.
• Strictly follow the laws and regulatory acts of the region where the device is used. This device can not be used for illegal purposes.
• Do not disassemble or repair device by yourself. In case of device failure, contact the service center.
NAVITEL s.r.o. hereby declares that the device NAVITEL R35 is compatible with the European directive RED 2014/53/EU.
The full text of Declaration of conformity is available at the following internet address:
www.navitel.cz/en/declaration_of_conformity/R35
NAVITEL R35 | 19
EN