Suntherm NG+ 80 Bedienungsanleitung Seite 7

PRODUCT DESCRIPTION
i i POPIS VÝROBKU
The heating panel is designed to heat or maintain residential, commercial or industrial areas. The front side of the
heating panel has been treated with a surface coating. The surface of the heating panel is smooth or sandblasted
depending on the panel type. It is a Class II appliance with IP 20 powered with 230V/50Hz. The product is equipped
with a thermostat to prevent overheating.
The product is designed to be installed on a wall. Plugging into the electrical mains is typically done by means of
a connecting cable ended with a sheathed male plug. Another option is to plug the inlet box at the back side of the
panel into the electrical mains.
The panel comes with a standard installation set for the brickwork. Make sure the anchoring material is suitable for
the chosen material, or if need be consult with the anchoring material supplier. The heating panel may be installed
on surfaces with Class A1, A2, B, C or D fire resistance rating. The dimensions and input power of the models are
listed in the table below.
TYPE
SUNTHERM NG+ 80
SUNTHERM NG+ 150
SUNTHERM NG+ 200
SUNTHERM NG+ 200dl
SUNTHERM NG+ 300
SUNTHERM NG+ 400
SUNTHERM NG+ 500
SUNTHERM NG+ 500dl
SUNTHERM NG+ 600
SUNTHERM NG+ 700
POWER (W) A (mm)
80 440
150 840
200 540
200 840
300 640
400 900
500 980
500 1040
600 1240
700 1240
X
B (mm)
260
260
540
390
640
540
640
540
540
640
7
X (mm)
425
825
525
825
625
875
965
1025
1225
1225