Werbung
4.1 Setting of memory location 2: see 3.1
4.2 Memory 2 Operation: see 3.2
5.1 Setting of memory location 3: see 3.1
5.2 Memory 3 Operation: see 3.2
6.1 Setting of memory location 4: see 3.1
6.2 Memory 4 Operation: see 3.2
7. Lock: press and hold
locked. No matter which button is operated, the motor will not work. The screen will turn off in 3s. In this case,
press any button. The screen will light up, displaying LOC for 3s, and then turn off, which will be repeated
without unlocking buttons. Then press and hold
will be unlocked, and the motor will work again.
Limit setting
1.1 Upper Limit Setting: press and hold
to the upper limit, and the screen will display HLS in a flashing state for 3s, and then remain in the HLS interface.
In this case, press any button to exit the limit display interface.
1.2 Low Limit Setting: press and hold
the lower limit, and the screen will display LLS in a flashing state for 3s, and then remain in the LLS interface. In
this case, press any button to exit the limit display interface.
1.3 Limit Clear: press and hold
and the screen will display LS- in a flashing state for 3s, and then remain in the LS- interface. In this case, press
any button to exit the limit display interface.
1.4 Change of the unit of height: change between centimeter and inch. Press and hold
enable the change between centimeter and inch. A21 represents "centimeter" while A22 represents "inch". The
unit will flash for 3s and then remain on the screen. Press any button to exit this interface.
2. Anti-collision & anti-pinch sensitivity adjustment: press and hold
anti-collision sensitivity by a level between A01 and A03. The screen will display the anti-collision sensitivity
corresponding to A01-A03. Repeat the above operation for adjust it again. The anti-collision sensitivity decreases
from A01 to A03. A01 represents the highest sensitivity while A03 represents the lowest sensitivity. (The default
setting is A02, i.e. the middle sensitivity.)
3. Change between long pressing and short pressing for memory location recall: press and hold
for 3s, to change the long press and short pressing modes. A11 represents long pressing, while A12 represents
short pressing. The mode will flash for 3s and remain on the screen. Press any button to exit this interface.
Height value adjustment
1. Run the motor to the lowest location, and press and hold
or
to adjust the value, and then press and hold
ㅤ
for 5s. The screen will display LOC in a flashing state for 3s, and buttons will be
and
and
,
and
for 5s. The screen will display the current height, buttons
at the same time for 3s. The current location will be set
at the same time for 3s. The current location will be set to
at the same time for 3s. The custom limits will be cleared,
and
for 10s. The LED indicator will flash. Press
for 5s to save this value.
and
for 3s to
for 3s to increase the
and
14
Werbung
