ADE M111600 Gebrauchsanweisung Seite 9

Insert batteries
- Please use two 2 x CR2032 (lithium) batteries.
- Open the battery compartment on the back side of the scale by loosening the fixing screws
carefully.
- Insert the batteries according to the pole markings (+/-), with the + pole of both batteries
pointing towards the bottom of the battery compartment.
- Please ensure that the battery compartment cover is in place and secured via the fixing
screws before starting up the scale.
- Please observe the valid legal regulations in your country, when disposing used batteries.
In case scale will not be used for a long period of time take the batteries out to protect the scale and
secure a long lifetime.
Weighing
To achieve a reliable result, make sure the scale is placed in a vertical position and no
load is hanging at the hook.
1. Press the ON/OFF key to start the scale. During the automatic zero and function test you will
see the indication `8888´ in the display before `0.00´ will come up in kg mode.
2. You may now use the scale. Make sure to use a weighing trouser or cloth supplied as
optional extra by ADE.
3. To switch the scale off press the ON/OFF key again. Additionally, the scale is equipped with
an automatic shut off function. Shutting down the scale after 60 seconds without use.
Tare function
Choosing this function, you may weigh the baby together with additional objects (e.g. nappy, vest
etc.) and the weighing trouser or cloth without influencing the net weight result of the baby.
1. Press ON and wait for `0.00´ indication on the display.
2. Hang the weighing cloth or trouser including other possible objects (nappy, vest etc.) at the
hook.
3. Press TARE to reset the scale to zero.
4. Remove all weights from the hook. The scale will now display the weight as negative value
and will hold the weight automatically.
5. Place the baby in the weighing trouser or cloth and hook it up to the scale. Press the HOLD
key to restart the weighing function. The scale will show the next weight of the baby.
6. To cancel all values, press TARE again or switch off the scale.
Change unit
Switch the scale on and press the SET key short in order to change the units from kg into lb or oz.
The scale will indicate the chosen units in the display.
Displaying the temperature
Switch the scale on and press the SET key and keep it pressed until the temperature is displayed.
Press the SET key again to return into the weighing mode. The temperature is shown in °C only.
M111600-230324-Rev007-UM-de-e
Installation of scale
Operation
8