i-box Attune Bedienungsanleitung Seite 8

8.8 Scan Settings
By default, the FM scan stores all available stations, even if the signal is weak and the audio quality is poor. It is best to
use the "Strong stations only" option to ensure the stations found have a clear signal, follow the steps below.
FM
ENTER
< Scan Setting > SCAN
9. Bluetooth Mode
Use the MODE key (5) to select Bluetooth mode, the screen will flash "Not Connected" to indicate that the Attune is in
pairing mode. Your Attune will automatically search for the last connected device. Connect a compatible device as
shown below. When your device is connected you will hear a chime.
Bluetooth
MODE
Not Connected
You don't need to re-pair. The Attune will automatically reconnect with your device when they are in range and both
are turned on.
To disconnect your device, long press the ENTER/SCAN key (9). You will hear a chime when your device has been
disconnected successfully. Your Attune is now ready to pair with a new device.
9.1 Playback Controls
Use your device to control playback or use the Attune'S controls for the following options:
• Previous track (11)
• Play/Pause track (9)
ENTER/SCAN
• Next track (10)
• Use the volume dial (7) to control the volume. You can also use your device to change the volume. Adjust the volume
on both your device and the Attune for optimum sound.
10. AUX IN Mode
Use the MODE key (5) to select AUX IN mode. Connect any audio device to the 3.5mm AUX IN port
your Attune. Use your device to control and select audio and use a combination of the volume on your device and the
Attune to adjust for optimum sound.
11. System Menu
The options are sleep, time, backlight, language, factory reset, software version.
System
INFO
MENU < Sleep >
System
< Factory Reset >
12. Sleep Function
In any audio mode you can use the sleep timer function to set a time period after which your Attune will switch off
automatically. The available options are: Sleep off, 15, 30, 45, 60 and 90 minutes. When the sleep function is in use, this
icon and the remaining time is displayed.
System
ENTER
< Sleep > SCAN
To turn off the sleep function, re-enter the sleep menu, and set to "Sleep off".
System
ENTER
< Sleep > SCAN
13. Backlight
13.3 Timeout
Select how long until the display enters dim level. The available options are: 10, 20, 30, 45, 60, 90, 120, 180 seconds
or on (the display will not dim).
Backlight
ENTER
< Timeout > SCAN
08 | i-box
Scan Setting *
< Strong stations >
Bluetooth
Available Devices
i-box Attune
System
< Time
System
ENTER
< SW version > SCAN
Set sleep time
Sleep off
Set sleep time
14 minutes
Timeout *
< 60 sec >
Scan Setting
< All Stations >
Bluetooth
Bluetooth
Available Devices
Connected
i-box Attune Connected
System
> < Backlight
Set sleep time
15 minutes
Set sleep time
Sleep off
Timeout
< 90 sec >
ENTER
SCAN
on the back of
15
System
> < Language
Absolute 80s 14
ENTER
SCAN Discover more at
Absolute 80s
ENTER
SCAN Discover more at
Timeout
ENTER
< 120 sec > SCAN
>