Werbung
VZ-1550H/E
CP-1550E
€)
MECHANICAL ADJUSTMENT
(PLAYER SECTION)
ADJUST-
ITEM
JIG
MENT
NEHECKY.
POINTS
Tracking | Bladed
1. With no record placed on
screw
the turntable, set the side
driver
A/B selector key to B
position.
2. Push the play key to allow
the tonearm to go down to
the side B turntable.
3. Turn the semivariable
resistor clockwise so that
the tonearm starts to move
toward inner circumference
of the turntable, and then
turn the semivariable
resistor counterclockwise
until the tonearm dis-
continues to move, and
shop it there.
Lead-in
| Biaded
Lead-in
Stylus tip is at the central part
position
driver
adjusting
of the lead-in groove.
LP record | Screw
Using a test record
or test
SSR-4005
LP
E
Lead-in:
2045
2
5
|
record
(Lead-out:
1341
18
Side A
Side B
Figure 20—1 LEAD-IN POSITION
Adjusement
Point
++
"9
3
1)
SSR-4005
4
Height
EP record | Cue damper]
1. With EP record being
of
Hexagon
{ guide angie
placed on the turntable, set
stylus
wrench
the side A/B selector key
to Aposition. Then push
the tonearm forward key
to allow the tonearm to
reach the record lead-in
position.
2. Adjust so that there is a
clearance of 6.5 mm
produced between the
tonearm and record surface.
3. Set the side A/B selector
key to B position, and
check to ensure that there is
a clearance of 9.5
+2 mm
between the tonearm and
record surface.
Tonearm
Figure 20—2 HEIGHT OF STYLUS
L
Turntable;
LP record|
Side A
Phono motor is kept
speed
which is
33r.p.m.
in rotation.
provided | speed :
Adjust VR801, VR802
a
Pcbieeeth
and VR803 in this order.
viewer
speed :
PLAYER
PWB
Baladed
VR802
screw
Side B
driver
45r.p.m.
speed :
VR803
Figure 20-3 TRACKING/TURNTABLE SPEED
—20—
Werbung
