cherubini PLUG&PLAY SHORT Einstellanleitungen Seite 16

RESTORING THE ORIGINAL CONFIGURATION
To restore the
configuration perform the procedure
as described below:
- Connect both the brown and black
motor wires under the same switch,
e.g. UP.
- Press the UP button for at least 2
seconds.
- Disconnect and then restore the
original control switch electrical
connections (see page 14).
PLUG & PLAY SHORT - PLUG & PLAY PLUS
INSTRUCTION FOR USE IN AUTOMATIC MODE
The tubular motor is very simple to be used and installed, it does not need any regulation
as it automatically detects the position of limit switch.
The rolling shutter must be equipped with:
a) security locks or stiff fixing springs,
b) fixed or removable stoppers for end slats.
It is very important to check the sturdiness of the rolling shutter.
A
original motor
B
UP DOWN
PLEASE NOTE: Until both limit switch
positions have been memorized:
- Plug & Play Plus at start up the motor
makes an initial brief movement with a
0.5 second delay and then it moves with a
0.5 second delay.
16
1- brown
2- black
3- blue
4- yellow-green