Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REMOTE CONTROL FUNCTION
RGB LED 'NEO MOTION' LIGHTING INSTRUCTIONS
SAFETY NOTES
•
The user of the Neo Motion LED must have read and understood these operating instructions prior to its
first use in order to safely use this product.
•
The LEDs must only be used when they functions properly. If the LEDs or part of the LEDs are defective,
please contact your retailer for advice and cease to use the lighting function.
•
Always keep the operating instructions within reach.
•
If you sell or pass on the device, you must also pass on these operating instructions.
•
Never use the LED function in a room where there is a danger of explosion or in the vicinity of flammable
liquids or gases.
•
The LEDs may only be connected to a grounded socket which has been installed professionally, is
grounded and checked.
•
Main power voltage and fuse must meet the Technical data specifications.
•
If the power cable or the device is damaged immediately turn off the plug and pull out the plug. Do not use
the Cable again and dispose of it properly.
•
Do not bend, crush or pull the cable, protect from sharp edges, oil and heat. • If the LEDs are not in use
make sure the plug is pulled out.
•
Do not touch the power connector with wet hands! Always unplug by pulling the connector, not the cable.
•
Do not lift the bed using the cable or use the cable for purposes other than intended.
•
The power cable may not be shortened.
Risk of damage to the eyes! Never look directly into the LED.
The light can only be used in dry indoor areas.
Not suitable for ordinary lighting in household room illumination
3
w/ww
w/ww
4
IC Set
IC Set
CS
CS
C3
C3
5
C7
C7
C16
C16
2
1
1
2
3
4
Auto
5
6
Flash
6
How to adjust the LED length:
Jump
Step 1 - Turn on the light
Step 2 - Press IC set button till LED light on
Meteor
Step 3 - Press "
Step 4-Press other buttons for effects.
Turn on/off
Change to mixed White or Warm White
Adjust brightness or speed
Set LED Strip length (details remark)
Change LED color
Different direction and effects of the light
" or "
" button to increase LED length or
decrease LED length till light on all LED on the strip
EN
17
Werbung
