Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General instructions
General installation instructions for MATCH
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installati-
on instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
damage to the unit, fire and/or risk of injury. For
a proper performance and to ensure full warranty
coverage, we strongly recommend to get this pro-
duct installed by an authorized MATCH dealer.
Install your PP 1SUB in a dry location with suf-
ficient air circulation for proper cooling of the
equipment. The amplifier should be secured to
a solid mounting surface using proper mounting
hardware. Before mounting, carefully examine the
area around and behind the proposed installati-
on location to insure that there are no electrical
cables or components, hydraulic brake lines or any
part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredictable
damage to these components and possible costly
repairs to the vehicle.
Warranty Disclaimer
The limited warranty comply with legal regulations.
Failures or damages caused by overload or impro-
per use are not covered by the warranty.
Please return the defective product only with a
valid proof of purchase and a detailed malfunction
description.
Technical specifications are subject to change!
Errors are reserved!
General instruction for connecting the PP 1SUB
amplifier
The PP 1SUB may only be installed in vehicles
which have a negative ground electrical system.
Any other system may cause damage to the
amplifier and the electrical system of the vehicle.
Use only the provided MATCH cable for con-
nection of the PP 1SUB. The use of other
cables can result in damage of the ampli-
fier, the head unit / radio or the connected
loudspeakers!
Prior to installation, plan the wire routing to
avoid any possible damage to the wire harness.
All cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
For damages on the vehicle and the device, caused
by handling errors of the device, we can't assume
liability.
All MATCH amplifiers are tagged with a E-Certifi-
cation number and also a CE-Certification mark.
Thereby these devices are ceritified for a use
inside vehicles inside the European Union (EU).
Werbung
