Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User manual
battery rear light TL-128 B
1. Introduction
Congratulations on the purchase of your new device. The user's manual is part of this device and
contains important information to safety, installation and disposal. Familiarize yourself with all
operating and safety instructions before using the device. Use the device as described and in
the specified areas of application. Keep this manual in a safe place and have it with you when
using the device.
2. Scope of delivery
1 rear light
1 user manual
3. Gebruikte symbolen
Products and packaging should be disposed of in an environmentally
friendly manner
Symbol for the detection of electrical and electronic equipment
Symbol: crossed-out garbage can
Do not dispose batteries / rechargeable batteries in the domestic waste
Port USB (Universal Serial Bus) pour connecter l'appareil par ex. à un
ordinateur (uniquement recharger)
K XXXX
Marque de contrôle de l'Office fédéral sur la circulation des véhicules
automobiles (KBA) (K suivi du numéro d'autorisation)
Recycling code for disposal of cardboard
Product complies with the product-specific applicable European directives
4. Proper use
The product is intended for use on bicycles and serves the illumination of the road and as a tail
light. This LED front light and the LED tail light are approved according to the currently valid
RTLR (StVZO) as sole lighting on all bikes. The product is intended for outdoor use. Any other use
than described above or alteration of the product is not permitted and may cause damage to
the product. The manufacturer assumes no liability for damage arising from improper use. The
product is not intended for commercial use.
5. Safety information
- Do not look into the light.
- The rear light must be mounted and adjusted so that the reference axis is parallel to the vehicle's
median longitudinal plane and parallel to the road.
- The light distribution may be obscured by no other attached parts or pieces of luggage, not
even partially.
- The batteries must be changed immediately when the control device is activated.
- The LEDs are not interchangeable. If the LED fails, the entire luminaire must be replaced.
Manual_TL-128 B
6. WARNING! LIFE AND ACCIDENT HAZARD FOR INFANTS AND CHILDREN!
Never leave children unattended with the packaging material, because of suffocation danger by
swallowing packaging parts. Always keep the device away from children. The device is not a toy!
This device can be used by children of age 8 and over and by persons with reduced physical
or mental capabilities or lack of experience and knowledge if they have been supervised or
instructed concerning the safe use of the device and by understanding resulting hazards.
Children are not allowed to play with the device. Cleaning and user maintenance should not be
carried out by children without supervision. Do not disassemble the device. Improper repairs can
cause significant risks for the user. Only have repairing made by qualified personnel.
7. Safety information of the batteries
- WARNING! DANGER OF LIFE! Batteries do not belong in children's hands. Do not leave batteries
lying around. There is a risk that they may be swallowed by children or pets. Ingestion may cause
chemical burns, perforation of soft tissue and death. Severe burns may occur within 2 hours of
ingestion. Seek medical attention immediately.
- DANGER OF EXPLOSION! Never recharge, short circuit and/or open non-rechargeable batteries.
Overheating, fire hazard or bursting may result. Never throw batteries into fire or water. The
batteries may explode.
- Remove used batteries from the product immediately. Otherwise there is an increased risk of
leakage.
- Always replace all batteries at the same time. Do not use different types or used and new
together.
- Check the batteries regularly for leakage
- Leaking or damaged batteries can cause burns if they come into contact with the skin; therefore,
be sure to wear suitable protective gloves in this case!
- Remove the batteries from the product if it will not be used for a long time.
- Do not subject batteries to mechanical stress
- Avoid contact with skin, eyes and mucous membranes. In case of contact with battery acids,
immediately rinse the affected areas with plenty of clean water and seek medical advice
immediately.
- Avoid extreme conditions and temperature that can affect batteries, e.g. on radiators
- Clean battery and product contact before insertion if necessary
8. Product presentation
①
④
③
9. Mapped components
rear light
1
on/off switch
2
integrated z-reflector
3
battery control device
4
10. Product assembly
Attach the rear light (1) to the luggage rack of your bike. To do this, use the supplied screws and
nuts.
11. Product adjustment
Reference axis
Reference axis
Attention!
Regularly check the correct setting and mounting height of your tail light. The tail light must be
mounted in an area of 250 to 1200mm above the roadway. It must be mounted and adjusted so
that the reference axis is parallel to the vehicle's median longitudinal plane and parallel to the
road surface (see pic.).
12. Batteries exchanging
In the upper left corner of the rear light there is a battery control (4). When the battery charge
is low, it lights up green. The batteries must be changed immediately when the control device ④
lights up.
Open the rear light by releasing the latch at the lower end and separating the front housing from
the rear housing. Insert two new batteries into the battery compartment according to the correct
polarity. Close the rear light again. Make sure that the housing closes completely.
②
Werbung
