Night Light Function - M-E Bell-250 Rx Betriebsanleitung

ENGLISH
BELL-250 RX
Note: If the receiver does not respond as expected, perform the following steps
for a factory reset:
Reset to factory defaults
1. Remove the receiver from the mains socket.
2. Wait for about 30 seconds.
3. Insert the receiver back into the mains socket, a double beep tone indicates
the reset and the transmitter(s) can be reconnected.
DOOR CHIME OPERATION
Melody selection
The chime melody can be individually set for each transmitter. It is also possible
to set different chime melodies for the front and the back door.
Press the "S" button to play the next chime melody. There are 8 different tones
to choose from. Please refer to the instruction manual of the transmitter to find
GB
out where the "S" button is located.

NIGHT LIGHT FUNCTION

Switching the night light function on/off
The night light function can be switched on or off with the
side switch (24).
When the night light function is switched on, the night light switches itself on
automatically in darkness and off at brightness. The brightness sensor (27) must
not be concealed, otherwise the light field illuminates continuously, no matter
how bright or dark it is.
16