First Time Operation - M-E Bell-250 Rx Betriebsanleitung

INSTALLATION
This receiver is operated directly in a 230V mains socket, no further installation is
necessary.

FIRST TIME OPERATION

This wireless bell is equipped with an automatic, self-learning digital encoding.
Please read these instructions carefully before first use to avoid any errors
during start-up.
Coding set-up between transmitter and receiver
Transmitter
After start-up of the transmitter the device responds to one of the 256 possible
encodings. This happens automatically.
Note: A maximum of 4 transmitters can be programmed to one receiver.
Receiver
1. When the receiver is plugged into a wall outlet, you will hear a double beep
tone.
2. Press the doorbell button on the outdoor unit, which the receiver should
respond to.
3. The receiver plays the set chime melody(see point 'Melody selection').
Additional transmitters (up to 4 units in total) can be programmed as follows
4. Press the code button (19) on the receiver until a single beep is heard.
5. The corresponding doorbell button must be pressed now within 6 seconds.
If this does not happen, the receiver exits the learning mode automatically,
followed by a double beep tone.
6. Repeat steps 4 and 5 to add more transmitters.
Note: The memory is full when the receiver has programmed four transmitters.
This is indicated by 4 beeps.
15
ENGLISH
BELL-250 RX
GB