Herunterladen Inhalt Inhalt Diese Seite drucken

Parts & Features; Operating Your Appliance - Scandomestic IC155D Anleitung

Eiscreme-gefrierschrank
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

PARTS & FEATURES
ICE-CREAM FREEZERS :
1 Glass doors
2 Baskets
3 Body
4 Power cord
5 Control panel
6 Castors
Supermarket CABINETS :
1 Glass doors
2 Power cord
3 Feet or Castors
4 Control panel
TRANSPORTATION AND
INSTALLATION INSTRUCTIONS
TRANSPORTATION:
1 When you transport the
appliance, the angle
between the
compartment body and
the ground should be no
more than 45°and you
should never place the
appliance up-side-down.
2 Do not use any of the
external parts as loading
points, for example, the
condenser on the back,
the door.
INSTALLATION:
1 When the appliance is installed or used, all the package
(including board and foam plastic) should be got rid of.
2 The minimum room temperature at the place of
installation is 10℃.
3 Keeping the appliance stable to avoid vibration and
noise.
4 The appliance should be installed in a place with good
ventilation, a space of at least 10cm should be allowed
between the surrounding walls and the cabinet wall for
air condition.
5 The appliance should be placed far from the heating
resource and not under direct sunshine to avoid a
decrease in the efficiency of refrigeration.
6 Install the appliance in a dry place to prevent rust on
the compartment body, which may affect the electric
insulation.
WARNING: When positioning the appliance ensure the
supply cord is not trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets
or portable power supplies at the rear of the appliance.

OPERATING YOUR APPLIANCE

POWER SUPPLY
The power supply should always be in accordance with the
rating plate on the back of the appliance; here you can
read the voltage (V) and frequency (Hz). The power supply
must always be in accordance with the law and regulation
of the country with regard to electrical safety. If you are in
doubt ask your supplier.
STARTING UP
If the compressor does not start when the appliance has
been plugged in, then the power supply of the unit is not in
order. Check if there is electricity running from the power
socket to the plug or if the fuse is blown.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis