Hama BSH-150 Handbuch Seite 7

00057186bda 24.03.2006 8:03 Uhr Seite 14
2. Software Installation
Note: Make sure the Bluetooth USB Adapter is unplug-
ged. To install the software, please follow the
instruction below.
1). Insert the Bluetooth driver installation CD
into the CD-ROM. The "InstallShield Wizard"
should start automatically. If it does not load,
please run the "Setup.exe" file from the CD drive.
2). A setup window will pop up. Click "Install" to start
installation process.
Note: The initial window varies depending on the
version of driver you are installing.
3). The Welcome window should now appear, Click
"Next".
4). Accept the terms in the license agreement then
click "Next".
5). Click "Install" to begin the installation.
6). Installation is in process.
7). Wait for the setup.
8). Plug in the EDR USB adapter and click "OK" to
continue the installation.
9). Click "Finish" when the installation is completed. 2). Press and hold the pairing button on the stereo
3). Click the "New Connection" button to start
10). Users will be asked to restart the system. Click
"Yes" to restart the computer immediately.
4). Select "Custom Mode" and click "Next".
3. Turn on the Power of Stereo headset
1). Use the power switch to turn on the power of the
stereo headset.
2). The blue indicator will be flashing when the power
is switched on.
5). System is searching for Bluetooth devices.
4. Pair Headset with your computer
The Headset needs to be paired before it can be used.
Please read the following instructions below for pairing
procedures.
1). Clicking Bluetooth icons on task bar to open the 6). Select "BSH-150" on the Bluetooth device list and
Bluetooth manager window.
headset for 6 seconds until the blue and red LEDs
are flashing alternately. (As fig. 1)
Bluetooth device searching. (As fig. 2)
click "Next". If the device does not show up,
make sure the stereo headset is in pairing mode,
(The blue and red LEDs flash alternately.) and
then click "Refresh" button to start searching again.