Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11.3 Installation of the the quartz glass heating element
Carefully insert the new heating element (3a) into the
casing. (Heating element is fragile) Insert both black wires
(E6) into the ceramic terminal (E5) of the new heating
element (3a). Use a suitable screwdriver to firmly tighten
both screws (E4) of the new heating element. The black
wiring shall be routed such as to maintain a minimum
distance of 1 - 2 centimetres from the white insulation of
the heating element.
When tightening the screws, ensure to hold the connector piece (E5) in
!
order to prevent it from twisting. Risk of short circuiting!
Now, push the heating element with front end of the quartz glass tube into the front guide
(E7) of the casing. Re-install the rear panel of the casing (E2). Ensure to slide the rear
guide (E8) over the rear end of the quartz glass tube. At the same time, adjust the casing's
wall (E2) to allow for the proper attachment of the casing's screws (E1). Tighten the
casing's screws (E1).
Do not pinch the wiring between the casing's wall (E2) and/or other
!
components of the casing! Do not pull on the connection wire (E3) of the
residual heat sensor and do not damage the insulation. Danger of elec-
tric shock! If the wires of the residual (E3) have moved, place them again
close to the lower casing part.
Finish the installation by re-inserting the ceramic annealing tube (3b) and depth stop (8)
into the quartz glass heating element (3a) and attach the splash guard (7) using both
screws (9).
!
Do not heat up the unit without assembled ceramic annealing tube (3b)!
Service adress:
WLD-TEC GmbH
Production & Service
Halle-Kasseler-Str.49
D-37318 Arenshausen
Germany
E3
E8
Phone: +49 36081 68940
Fax: +49 36081 68942
Email: sales@wld-tec.com
Internet: www.wld-tec.com
E7
EN
E6
E2
Fig. 11/5
25
Werbung
