Wld-Tec SteriMax Bedienungsanleitung Seite 23

8. Holder installation (optional)
Before installing the holder turn off the
!
device, wait for it to cool down and unplug it!
Two optional holders are available for the SteriMax:
1. Holding device, specially developed for WLD-TEC
inoculation loop holders, made of stainless steel,
available for all angle settings,
2. Support for all inoculation loop holders, made of
stainless steel; can only be used in the first three
angle settings, Art. No.: 5.000.101.
Both holders will be attached to the underside of the annealing tube's casing using
two short screws (included with delivery of the holder). When installing the holders,
first push the screws (Z1) through the slots of the holder (Z2) and slightly tighten the
screws in the tapped hole on the underside of the tube's casing. Subsequently, insert
an inoculation loop holder and slide the holder into the desired position. Tighten the
screws (Z1).
9. Warranty
All SteriMax are covered under our two-year manufacturer warranty against any
manufacture defects in material and workmanship, except parts to wear and tear
(Quartz glass heating element 3a & ceramic annealing tube 3b).
The WLD-TEC warranty guarantees all SteriMax under normal usage conditions
and does not cover any damages as a direct result of user misuse or / and abuse.
The warranty is void upon any unauthorized servicing, disassembly or modifications.
10. Troubleshooting guide
• Device does not work
Ensure the mains cable is connected properly.
(see paragraph 1).
Check fuse, replace if necessary.
(see paragraph 7).
• Annealing tube (3) does not heat up, even though the device is turned on and
the master switch's green light is illuminated.
Heating element may be defect. Have it replaced by qualified person
only! (see paragraph 11).
Art. No.: 5.000.100.
Z2
Z1
Fig. 8/1
EN
23