Specification; System Requirement; Software-Installation - i-tec MySafe USB 3.0 Easy Gebrauchsanweisung

i-tec MySafe USB 3.0 Easy

SPECIFICATION

External USB 3.0 enclosure for 2.5" SATA I / II / III hard disk
Ÿ
drives
Transfer interface: 1x USB 3.0
Ÿ
Compatible with all 2.5" SATA HDD (with height up to 9.5 mm)
Ÿ
Backward compatible with USB 2.0 devices
Ÿ
Supports the following speed data rates: SuperSpeed
Ÿ
(5Gbps) / HighSpeed (480Mbps) / FullSpeed (12Mbps) /
LowSpeed (1.5Mbps)
Plug & Play
Ÿ
Active LED to indicate HDD status (it shines – HDD is
Ÿ
connected, it twinkles – record/reading is underway)
Power supply 5 V, 900 mA
Ÿ
Weight: 60 g
Ÿ
Size: 130 x 74 x 16 mm
Ÿ

SYSTEM REQUIREMENT

Windows XP/Vista/7/8/8.1/10 32/64bit, Mac OS 10.x and higher –
automatic installation of drivers from OS
Available USB port (we recommend using free USB 3.0 port to use
maximal speed of HDD).
HARDWARE INSTALLATION OF SATA HDD
Proceed according to following instruction:
1. Open the enclosure and take out the adapter with an built-in
USB cable.
2. Insert HDD, the SATA connector should fit into the slot of
enclosure, and close it.
3. Connect the adapter with an built-in USB cable on the other side
(to HDD) and close the enclosure.
SOFTWARE INSTALLATION
Windows 2000/XP/Vista/7/8/8.1/10 32/64bit or Mac OS 10.x
and higher
After the connection to computer the system will detect equipment
and will complete the driver installation automatically.
Note: For proper device functionality you have to format the HDD
first. Follow the instructions below.
EN
05