Herunterladen Inhalt Inhalt Diese Seite drucken

Recognising And Repairing Of Mistakes; Notes On Product Liability; Notes On Disposal; Eu Declaration Of Conformity - profi-pumpe Zwei-Wege-Ventil AQUA-VALVE 4 DN20 Bedienungsanleitung

2-/3-wege umschaltventile
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

8. RECOGNISING AND REPAIRING OF MISTAKES

Problem
Valve opening and closing positions
are opposite
The actuator does not run
Connection of the screw thread is
cracked
Valve cannot be opened or closed
thoroughly

9. NOTES ON PRODUCT LIABILITY

We point out, that we are only liable for damages under the Product Liability Act, which are caused by our units if no
changes were made to the equipment. If repairs are carried out by our authorized service, we are only liable if original
spare parts and accessories were used.

10. NOTES ON DISPOSAL

Electro devices of our company, labeled with the symbol of the crossed trash bin, are not permitted to
be disposed in your household garbage. We are registered at the German registration department EAR
under the WEEE-No. DE25523173. This symbol means, that you're not allowed to treat this product as
a regular household waste item – it has to be disposed at a recycling collection point of electrical devices.
This is the best way to save and protect our earth.
THANK YOU FOR YOUR SUPPORT!

11. EU DECLARATION OF CONFORMITY

The products listed overleaf accordance with the marketed in accordance with the relevant provisions listed below, the
relevant EU directives and harmonized with EU standards for safety. This declaration is valid insofar on the product,
no changes are made.
Authorized person to keep the technical documents:
1A-Profi-Handels GmbH · Unterriethstraße 37 · D-65187 Wiesbaden
EC Electromagnetic compatibility directive (2004/108/EC)
The following harmonized standards:
EN 61000-6-3:2007+A1:2011
EN 61000-6-1:2007
EN 61000-3-2:2006+A1:2009+A2:2009
EN 61000-3-3:2013
Wiesbaden, 12th March 2017
Peter Neumüller
Possible cause
Wrong wire connection
1. Wrong wire connection; circuitry
is burnt
2. There is too much condensation
or the motor is damaged
1. Used wrong screw
2. Improper installation or over force
installation
Jammed with tiny dirt particles or
water quality is poor
English 5
Solution
Exchange the valve opening and
closing wires
1. Check the power supply and the
circuitry of the thermostat
2. Exchange the actuator
Exchange the valve body
Clean up sundries or add a pre-filter

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis